Search results for "Fission product"
showing 10 items of 100 documents
Theoretical and experimental studies of the neutron rich fission product yields at intermediate energies
2012
A new method to measure the fission product independent yields employing the ion guide technique and a Penning trap as a precision mass filter, which allows an unambiguous identification of the nuclides is presented. The method was used to determine the independent yields in the proton-induced fission of 232 Th and 238 U at 25 MeV. The data were analyzed with the consistent model for description of the fission product formation cross section at the projectile energies up to 100 MeV. Pre-compound nucleon emission is described with the two-component exciton model using Monte Carlo method. Decay of excited compound nuclei is treated within time-dependent statistical model with inclusion of the…
Direct identification of 103–107Mo by a rapid chemical separation procedure
1977
Abstract The nuclides 103–107Mo have been identified by means of γ-ray spectroscopy after the separation of molybdenum from fission products of 235U and 239Pu by a rapid chemical procedure. Half-lives of 67.5 ± 1.5 s for 103Mo, 59.4 ± 0.8 s for 104Mo, 36.7 ± 1.0 s for 105Mo, 8.4 ± 0.5 s for 106Mo and 3.5 ± 0.5 s for 107Mo have been determined and the main γ-lines were assigned to the decay of these isotopes. Some evidence for 108Mo with a half-life ≤2 s has also been obtained.
A system for rapid radiochemical separations from aqueous solutions
1969
Abstract For the study of short-lived fission products, an automatic system has been developed that allows to irradiate aqueous solutions sealed in polystyrene capsules, to separate chemically the radioactive products formed, and to start counting, all within a few seconds. Irradiations are performed in a pneumatic tube system installed in a horizontal beam hole of a reactor. The capsule is projected into a separation apparatus where it breaks by impact. Its content is then sucked through a thin reactive layer that takes up the desired product. The whole sequence of irradiation, transportation, chemical separation, and counting is controlled by automatic timers. The adaption of this techniq…
Mass-asymmetric fission in the 40ca+142Nd reaction
2016
Shell effects play a major role in fission. Mass-asymmetric fission observed in the spontaneous and low energy fission of actinide nuclei was explained by incorporating the fragment shell properties in liquid drop model. Asymmetric fission has also been observed in the low energy fission of neutron-deficient 180 Hg nuclei in recent β -delayed fission experiments. This low-energy β -delayed fission has been explained in terms of strong shell effects in pre-scission configurations associated with the system after capture. Calculations predicted asymmetric fission for heavier Hg isotopes as well, at compound nuclear excitation energy as high as 40 MeV. To explore the evolution of fission fragm…
Gas phase synthesis of 4d transition metal carbonyl complexes with thermalized fission fragments in single-atom reactions
2021
Abstract The formation of carbonyl complexes using atom-at-a-time quantities of short-lived transition metals from fusion and fission reactions was reported in 2012. Numerous studies focussing on this chemical system, which is also applicable for the superheavy elements followed. We report on a novel two-chamber approach for the synthesis of such complexes that allows spatial decoupling of thermalization and gas-phase carbonyl complex synthesis. Neutron induced fission on 235U and spontaneous fission of 248Cm were employed for the production of the fission products. These were stopped inside a gas volume behind the target and flushed with an inert-gas flow into a second chamber. This was fl…
Über die schnelle Trennung des Rutheniums von den Spaltprodukten des Urans
1971
Measurements of isomeric yield ratios of fission products from proton-induced fission on natU and 232Th via direct ion counting
2017
Independent isomeric yield ratios (IYR) of 81Ge, 96Y, 97Y, 97Nb, 128Sn and 130Sn have been determined in the 25 MeV proton-induced fission of natU and 232Th. The measurements were performed at the Ion Guide Isotope Separator On-Line (IGISOL) facility at the University of Jyväskylä. A direct ion counting measurement of the isomeric fission yield ratios was accomplished for the first time, registering the fission products in less than a second after their production. In addition, the IYRs of natU were measured by means of γ-spectroscopy in order to verify the consistency of the recently upgraded experimental setup. From the obtained results, indications of a dependence of the production rate …
Trennung von spaltprodukten durch Extraktionschromatographie
1970
The separation of fission products which form anionic species in mineral acids and of uranium and neptunium from samples of neutron-irradiated uranium is described. The method used is extraction chromatography with tri-n-butylphosphate (TBP) and di-(2-ethylhexyl)-orthophosphoric acid (HDEHP) as extractants and polytrifluoromonochloroethylene powder as the solid support. In the first column Zr, U and Np are extracted with TBP from 8N HNO3/NaClO3. In the second column, HDEHP is applied as extractant and 9N HCl/NaClO3 as the mobile phase for the isolation of Nb, Sb, and I, and in the third column (HDEHP), the rare earths and Mo are extracted from 0.1N HCl. Finally with the fourth column (TBP),…
Studies of short-lived fission products by means of the multistage solvent extraction system SISAK
1990
The multistage solvent extraction system SISAK is described. The system is used for online studies of nuclides with half-lives down to ∼1 s. Some of the chemical separation procedures are presented, and a survey is given on the results obtained so far. The possiblity to gain access to nuclides with even shorter half-lives is also discussed.